Drinking water contamination is the great enemy to your prized effect wrench and other costly air resources.
The widespread misconception is that if you just drain the air supply tank in your air compressor of excess h2o, you are guarding your air instrument from water hurt. Even though draining your air supply tank is great, you are only preventing rust harm in the tank. The air outlet is usually at the prime of the tank and the drinking water in the bottom doesnt make it up there to damage your effect wrench.
How then does h2o get into your air lines and then to your air instrument?
The response is condensation.
H2o condenses and builds up in the air hoses and then travels to your air resource. Also, on a cold winter season early morning the h2o that has accrued in your air lines will freeze and result in even a lot more hurt. Frozen drinking water can break loose and hurt your resources or even block the air flow in the line.
The resolution to this difficulty is install a drinking water filter in your air hose. A good location to place it is midway down your air hose. There it will be out of the way when use your influence wrench under your car and you are trying to get into a restricted area. A small investment in a water filter will go a extended to prolong the daily life of your costly air instruments.
Related Sites : ingersoll rand tools